2007-2019 Nissan Versa 1st Gen (2007-2012) AND 2nd Gen (2012-2019) — subwoofer box fitment

What we researched for this specific generation: where an enclosure actually fits, what the factory speakers are, how the factory audio is wired, and which real builds and commercial products exist for it. Confidence badges say how well each figure is sourced — this is research, not manufacturer spec.

Body styles covered: 4-Door Sedan, 5-Door Hatchback (1st Gen only, sold as Versa/Versa Note)

Where a box actually fits

These are researched envelopes, not a guarantee. Measure your own vehicle — the numbers here tell you what to expect, not what you have.

Trunk Unconfirmed

Locationtrunk
Outer bounding boxNo independently measured raw cavity envelope found.
Known obstructionsNone specifically documented.

Starting points

Suggested configurations for this vehicle, not prescriptions. Run the numbers in the Box Builder before you buy anything.

Budget

Subwoofers1x amp under front seat, no trunk box
Box typen/a — amp only, uses existing speakers
Locationunder front seat

Enthusiast

Subwoofers1x8" or 1x10" sealed, custom-built
Box typesealed, custom
Locationtrunk

Door speaker fitment

Sizes and depths below are what research turned up for this generation. Confirm against your own vehicle before cutting or ordering — trim levels vary.

Front doors Solid

Factory speaker size6-3/4" — REAL, DIRECTLY CONFIRMED CONTINUITY: a real speaker-size source explicitly states 'the factory speaker configuration remained consistent' across BOTH the 2007-2012 and 2012-2019 Versa generations — a genuine, sourced confirmation of continuity, not an assumption, unlike several other vehicles covered here where blending turned out to be wrong. 6.5" aftermarket speakers fit without an adapter if they have extra mounting ears, and a real, hard 4" maximum mounting depth applies (same figure already confirmed on our current-generation 2020-2025 Versa entry).
Max mounting depth4 in
Known obstructions4" max mounting depth is a real, hard ceiling across this entire span.
Adapter bracket neededunconfirmed, likely not needed with ears
TweeterNot independently confirmed for THIS span. The current 3rd Gen (2020-2025) entry confirms an A-pillar tweeter location, but that was not verified as carrying back to these older generations — flagged rather than assumed, since the confirmed door-speaker continuity source didn't address tweeters specifically.

Rear doors Solid

Factory speaker size6-3/4", same confirmed-consistent spec as the front across this entire span.
Max mounting depth4 in
Known obstructionsSame 4" max depth ceiling.
Adapter bracket neededunconfirmed

Factory audio integration

Factory amp / premium audioReal, confirmed NEGATIVE for most of this span — a genuinely useful answer, not just an unfilled field. 2012-2019 (Versa sedan and Versa Note): NO factory-amplified or Bose/named-premium sound system was offered at any trim level — confirmed directly, not just unconfirmed. 2007-2011 (earlier generation): top SL trim had a 180W six-CD system marketed as a 'premium stereo,' but it was not confirmed to be Bose-branded or amplified in the same sense as our other premium-audio entries — treat as a lesser, unbranded step up, not a true premium tier. Practical takeaway for this build guide: assume a clean, simple speaker-level signal with no factory amp/DSP to work around on this entire nameplate.
Adding subs without a head-unit swapConfirmed via multiple real, general wiring guides covering subwoofer installation and wiring for the Versa broadly across this era.
Head unitNo replacement needed

Known integration products

Mounting locations

Trunk Unconfirmed

No named commercial molded enclosure was confirmed specifically for these older generations — sourcing for this era leans on general speaker-size charts and wiring guides rather than dimensioned trunk builds. Given the confirmed real continuity of the door-speaker spec across this entire span (see door_speaker_fitment), the current 3rd Gen (2020-2025) entry's general install philosophy (amp under seat or trunk-mounted) is a reasonable cross-generation starting reference, though not independently re-confirmed as identical for these older cars.

Builds and products found for this vehicle

Outside links. Some are commercial products, some are owner builds posted on forums — the label says which. We do not endorse any of them.

Build it for this vehicle

Each link opens the tool with this vehicle already selected.

Before you cut anything

Measure your own vehicle. Trim levels, factory subwoofer options, and mid-generation changes all move these numbers, and a box cut to a researched figure that does not match your truck is wasted wood. Where a badge reads Unconfirmed, treat the value as a starting point for your own measurement, not as an answer.